HYBREX G1E, Инструкция по установке и программированию

Страница: 172 / 219

156
Issue 3.3.2 / April, 2011
Program 50-stn-IP : Station Class of Service – 5
50-stn-IP STCOS
0 0 0 0 0 0 0 0
st = Station No. (2-4 digits) IP = 01-08
System Default
Item Display
Pointer Data Programming Data Description Default
---------- ---------- ----------------------------------------------------------- -----------
01 0-1 ACP Warning Signals 0=Disable
02 0-1 Call Forward Indication 0=Enabled
03 0-1 ISDN Incoming Call Display type-Digital phone 0=CLI
04 0-1 CTI-Extension Status Report 0=Disable
05 0-1 VMS Leading Digits for Intercom Calls 0=Enable
06 0-1 ACP Door Unlock Relay 0=ACP Relay
07 0-1 ACP Door Open Control 0=Card or P/Word
08 0-1 ACP Phone Operation Type 0=Door Phone
General:
This program permits each station to be assigned to a different Class of Service.
Description:
01. ACP Warning Signals:
This Parameter enables the warning signals for the ACP/RFID unit. The warning signals are Case Open Alarm
and Unplug Alarm.
0
= Disable 1 = Enable
02. Call Forward Indication:
This feature will disable the flashing SPK key on a handset that has enabled Call Forward.
0 = Disable 1 = Enable
03. ISDN Incoming Call Display Type-Digital Phone:
This parameter selects what will be displayed on the screen of an LCD phone when an incoming call is received,
either the CLI number or the ISDN Indial number. This will also select what will be displayed on the SMDR
output for incoming calls. This setting also allows the naming of Indials or CLI numbers using System Speed Dial
Name / numbers. If this setting is a 1 then when an incoming call with CLI or an Indial number rings the G1E will
search the System Speed dials and if this number is entered then the name associated with it will be displayed
on the screen. Because ISDN CLI currently omits the 0 on CLI It will be necessary to set Mode 84 – Home Area
code to correct the settings before searching. The Indial number is entered as the standard 7/8digit number
without area code. The SLT phone on the G1E will only display the calling number not the name
0 = CLI / Name 1 = ISDN Indial Number / Name