HYBREX G1E, Инструкция по установке и программированию

Страница: 92 / 219

76
Issue 3.3.2 / April, 2011
Program 05-08-IP : System Timing Parameters – 08
05-08-IP SYS PAR
3 0 3 0 7 2 4 0
IP = 01-08
System Default.
Item Display Programming Data Timing
Pointer Data Description Table Default
---------- ---------- -------------------------------------------------- ---------- ------------
01 0-9 Ring Hunt Time Setting C 3=6 Sec.
02 0-1 DSS Access To Other Trunk Group 0=Enable
03 0-9 SLT Camp On Tone 9=t x 9
04 0-1 DISA Transfer Group (No Answer) 0=Station Group
05 0-8 SLT Programming digit 7=7 + Code
06 0-9 DISA Transfer Time No Answer or Busy 2=24 Sec.
07 0-9 DISA Transfer Time No Dialling 4=4 Sec.
08 0-1 Music source selection 0=MBU Flash
Description:
01. Ring Hunt Time Setting:
If setting is n, Then when an incoming call rings the first ring assigned extension and that extension is
busy, after n seconds the call will ring the second of the ring assigned extensions. If the 2nd extension is
busy the call will go to the 3rd extension immediately. All stations which have been passed by the ring
assignment will receive off hook busy remind. Up to 26 stations can be in the ring group. If the setting is
0 then only the first ring assigned station will ring.
See timing table C for parameters of this feature.
02. DSS Access To Other Trunk group:
This feature enables or disables the ability of stations to use a DSS key to answer Ringing CO lines not
in their own group.
0 = Enable. 1 = Disable
03. SLT Camp On Tone:
This feature enables a tone to indicate call waiting for a busy Analogue phone and sets the interval
between tones. The interval between tones will be the Off Hook Busy Remind Interval (t) x by the setting
in this parameter. Off Hook Busy Remind Time is set in Mode 05-01-05.
0 = Disable 1 = t x 1 2 = t x 2 ......... 9 = t x 9
04. DISA Transfer Group:
This parameter decides to which group an unsuccessful DISA call will be transferred if the called station
has transfer enabled in Mode 46-st-04.
0 = Called Station's group console 1 = Incoming Trunk's group console
05. SLT Programming Digit:
This feature changes the programming digit used by an Analogue phone to perform its programmable
features. For example call forward is normally 701, If this parameter is set to 3 the call forward code will
be 301. If the setting is 0 then the analogue phones cannot do programming. If the setting is 8 it is
necessary to press [*][#] before accessing programming or dialling any 8 codes. This will allow the use
of digits 1 to 8 as the first digits of station numbers.
0 = Disable 1 = 1xx 2 = 2xx 3 = 3xx 4 = 4xx .... 7 = 7xx
8 = [*][#][7] for programming, [*][#][8] to access functions beginning with 8.