HYBREX G1E, Инструкция по установке и программированию

Страница: 89 / 219

G1E Programming Manual
73
05. Operator Code:
This parameter is to set whether to dial "0" or "9" for the operator or for accessing a CO. line.
1 = Dial "9" for operator, "0" for C.O. line.
0 = Dial "0" for operator, "9" for C.O. line.
06. Unsupervised Conference and ECF Time Setting:
This parameter sets the time that the system will allow an Unsupervised Conference or External Call
Forward to continue before sending a warning tone to the parties and then disconnecting the call. If
either party sends a DTMF digit (0-9) to the system the timer will reset and allow the call to continue for
the time setting. If reversal supervision is used it will override this setting.
0 = No Limit 1 = 1 Min. 2 = 2 Min. 3 = 3 Min. 4-9 = 4 Min.
07. Hold Feature for SLT:
This parameter is to set whether Single Line Telephones use [FLASH] (or [Hook-switch]) or [FLASH, 7]
(or [Hook-switch, 7]) to place a call on Hold.
0 = Normal -----> Using [FLASH] or [Hook-switch] to put a call on Hold.
1 = Alternate --> Using [FLASH, 7] or [Hook-switch, 7] to put a call on Hold.
08. Station Hunting Group Ring Method:
This parameter sets the ring method used in the station hunting groups. Pilot numbers for hunt groups
are set in Mode 67 and Day/Night ring stations are set in Mode 68 & 69. Individual Hunt Group Ring type
is programmable in program 67-gp-02 and will over ride the system wide setting made here.
0 = Common 1 = Linear 2 = Circular
TIMING TABLE
Grade 0 1 2 3 4 5 6 7 8 9 Unit
M 5 10 15 20 30 40 50 60 70 -
M(Taiwan) 12 16 20 24 30 60 90 120 180 -