Gx
Series
EN - 119
52
During this whole phase, do not disconnect the
measuring terminals of the instrument from the system.
In case of positive result (
Z
L-PE
or
Z
L-N
LOWER or
EQUAL to limit impedance relative to protection
device within the specified time
– see § 13.7), the
screen to the side is displayed by the instrument.
Press again the
GO/STOP
key
for a few seconds
to
repeat the test
Press the
SAVE
key or touch the icon
for the
partial saving of the test and follows with the next test
(point 55)
53 In case of negative result (
Z
L-PE
or
Z
L-N
HIGHER to limit
impedance relative to protection device within the
specified time
– see § 13.7), the screen to the side is
displayed by the instrument.
Note the presence of the
result of the measurement highlighted in red.
Press again the
GO/STOP
key
for a few seconds
to
repeat the test
Press the
SAVE
key or touch the icon
for the
partial saving of the test and to
end the test sequence
.
The instrument shows the message shown in the
followed screen for a few seconds
54 Repeat the sequence again if necessary
