HT Italia GSC53N, Инструкция по эксплуатации, Страница: 77 / 152

GSC53N - GSC57 - ZG47
EN - 75
8.1.4. How to set the Clamp Type
The value of this parameter must be always equal to the clamp type you are using.
Two types of clamps are available:
 STD: for Standard clamps or Current Transformer.
 FlexEXT: for Flexible clamps with External electronic control box
 FlexINT: for Flexible clamps without any electronic control box (GSC53N and
ZG47).
Set the desired value by pressing the keys
F3 and F4 .
WARNING
If “FlexINT” is selected ( GSC53N and ZG47 ), the current range could be set
only to 1000A or 3000A.
8.1.5. How to set the value of the transformer voltage ratio (TV RATIO)
The instrument can also be interfaced with step-down transformers in the equipment under
test: it can display the value of he voltages present on the primary winding of these
transformers. To do this it will be necessary to set the value of the transformers’ windings
ratio from 2:1 to 3000:1. The default is set at 1:1 for measurements of none transformer
systems.
Select “TV RATIO” in the ANALYSER CONFIG menu. Set the desired value by pressing
the keys
F3 and F4 .
8.1.6. How to enable/disable the password
The instrument is provided with a protective routine to avoid the risk of being disturbed or
interrupted during a recording or an energy measurement. Once a recording or a direct
energy measurement has been started (with the option “PASSWORD” enabled), after
about 3 minutes from the last key pressure or switch rotation it won’t be possible to press
START/STOP to stop the recording, “PASSWORD” will be displayed and it will be
necessary to insert the password.
In order to insert the password (which is not changeable), press the multifunction keys in
the following sequence (within 10 seconds):
F1 , F4 , F3 , F2
If you wait more than about 10 seconds the display will return to the meter mode and the
instrument will continue recording. If you insert a wrong password the message “Password
error” will be displayed under “PASSWORD”. After a few seconds the display will return to
meter mode and the instrument will continue recording. In order to enable/disable this
option the correct password will have to be entered. The display will return to meter mode
and START/STOP will have to be pressed again to stop the recording. You will then need
to re-enter the “ANALYSER CONFIG” menu and scroll up or down to the item
“PASSWORD: ON” using the keys
F1 and F2. Then turn the password off by pressing the
keys F3 and F4 .