HP NonStop RDF, Руководство по управлению

Страница: 452 / 478

Recovery Check the contents of the RDF configuration file, issue a VALIDATE RDF command
to verify the configuration, and reissue your request for the RDFCOM operation you originally
wanted to perform.
TMF NAT table is full.
Cause
There is a problem with TMF.
Effect The configuration validation fails.
Recovery Check the status of TMF. When TMF is operational, reenter the command.
TMF Shutdown at timestamp has been found. RDF starts with MAT file
filename at RBA relative-byte-address
timestamp
is the shutdown timestamp sought.
filename
is the name of the MAT file that contained the record with the matching timestamp.
relative-byte-address
is the relative byte address where the record with the matching timestamp was found in
the MAT file.
Cause RDFCOM has found the TMF shutdown timestamp identical to the timestamp specified
in the INITIALIZE RDF
timestamp
command.
Effect RDF is ready to be initialized at the specified timestamp.
Recovery This is an informational message; no recovery is required.
TMF STOP in progress.
Cause A TMF stop operation is in progress.
Effect TMF stops, and RDF automatically stops thereafter.
Recovery
This is an informational message; no recovery is required.
To issue this command, the RTD time of the extractor must be 0:00. Have
you confirmed that the RTD is 0:00?
Cause You are attempting to execute an RDFCOM STOP SYNCH command. To ensure that
the extractor does not miss any audit record, the extractor RTD must be 0:00 before executing
this command.
Effect You are prompted for a “yes” or “no” response.
Recovery
Enter YES (or Y) to execute the command or NO (or N) to cancel it.
Too many volumes are configured (number > max)
max
is 64 for RDF, and 255 for the RDF/MP, MPX, IMP, or IMPX
Cause
The maximum number of volumes that can be protected on a node (64 for RDF, 255
for RDF/MP, MPX, IMP, or IMPX) has been exceeded.
Effect The configuration validation fails.
Recovery Delete some of the volumes.
Too many volumes are specified in this ALTER command
Cause You specified too many volumes in the command parameter list of an ALTER
command.
Effect The ALTER command aborts.
Recovery
Eliminate some of the volumes from the command parameter list.
Triple Contingency CopyAudit command aborted.
452 Messages