HP NonStop RDF, Руководство по управлению

Страница: 226 / 478

BACKUPSYSTEM
backup-system
For a network master, specifies the name of the associated backup system.
For a nonnetwork master, specifies the name of the network master’s backup system.
REMOTECONTROLSUBVOLUME subvolume
For a network master, specifies the name of the primary system’s remote control subvolume.
For a nonnetwork master, specifies the name of the network master’s remote control
subvolume.
PNETTXVOLUME $volume
For a network master, specifies the name of the primary system volume on which the RDF
subsystem stores an audited network synchronization file.
Where Issued
Primary system only.
Security Restrictions
None.
RDF State Requirements
None.
Usage Guidelines
The SET NETWORK command enters the RDF network parameter values specified in this
command into the RDF configuration table in memory. This table serves as an input buffer only,
and so these values do not affect the subsystem until they are applied to the RDF configuration
file with the ADD command.
Example
To configure the primary system \RDF04 and backup system \RDF06, issue the following
commands after RDF has been initialized:
SET NETWORK PRIMARYSYSTEM \RDF04
SET NETWORK BACKUPSYSTEM \RDF06
SET NETWORK REMOTECONTROLSUBVOLUME RDF04
SET NETWORK PNETTXVOLUME $DATA07
ADD NETWORK
SET PURGER
The SET PURGER command sets purger process configuration parameters within the RDF
configuration memory table. The supplied values are not applied to the RDF configuration file,
however, until you issue an ADD PURGER command.
SET PURGER purger-option
where purger-option is:
{CPUS primary-CPU : backup-CPU }
{PRIORITY priority
}
{PROCESS process-name }
{PURGETIME mins }
{RETAINCOUNT num }
CPUS
primary-CPU
:
backup-CPU
identifies the CPUs in which the purger process is to run as a process pair on the backup
system;
primary-CPU
is the primary CPU;
backup-CPU
is the backup CPU. Values range
from 0 through 15. The default is 0:1.
226 Entering RDFCOM Commands