HP NonStop RDF, Руководство по управлению

Страница: 370 / 478

Recovery See the description of the NEWPROCESS procedure in the Guardian Procedure
Errors and Messages Manual to determine the cause of the failure. Once the underlying cause
is corrected, the backup process can be created.
714
CHECKPOINT Failure - backup comm error error
error
is the file-system error number that identifies the specific error.
Cause A call to the checkpoint procedure failed, and the backup process of a NonStop process
pair is still running. The message includes the number of the file-system error that was
encountered when the primary process was trying to communicate with the backup process.
Effect The backup process is stopped, and a new one is created after about 15 seconds.
Recovery See the description of the CHECKPOINT procedure in the Guardian Procedure Calls
Reference Manual to determine the cause of the failure. If possible, correct the underlying cause
to avoid its reoccurrence.
715
Primary stopped
Cause
The primary process of a NonStop process pair has stopped. This probably was the
result of an operator inadvertently issuing a STOP command from TACL.
Effect
The backup process takes over, but not in fault-tolerant mode, until the primary process
can be re-created.
Recovery
This is an informational message; no recovery is required.
716
Primary abended
Cause
The primary process of a NonStop process pair has abended.
Effect
The backup process takes over, but not in fault-tolerant mode, until the primary process
can be re-created.
Recovery
Scan the EMS event log to determine why the process abended. An INSPECT
SAVEABEND file should have been created in the volume and subvolume where you placed
the RDF/IMP software; you should save that file for problem resolution by your service
provider.
717
Primary processor down
Cause The primary CPU of a NonStop process pair has stopped.
Effect The backup process takes over, but not in fault-tolerant mode. The primary process
will be re-created after its CPU is reloaded.
Recovery Reload the downed processor.
718
Switched to original primary processor
Cause The original backup process of a NonStop process pair has successfully created a
backup process in the configured primary processor and has successfully switched processing
to that process.
Effect The NonStop process pair is switching primary and backup roles so that the primary
process is now running in the CPU configured as the primary processor.
Recovery This is an informational message; no recovery is required.
370 Messages