HP NetServer AA 6200, Руководство администратора

Страница: 79 / 272

Endurance Manager 4-17
Table 4-8 Display and Control Window Options
Option Description
Command
Description When a command is selected, this area displays a brief description of the command.
Filters Applies a filter to Target . The filter is applied when the checkbox for a command is not
displayed. The filters shown are:
•
Devices -- affects whether keyboard, SCSI disk, Ethernet, and tape commands are
displayed in Target .
• Elements -- affects whether CE, IOP, and ESI commands are displayed in Target .
• Drivers -- affects whether IOPn.Monitor and any IOPn.X.Provider commands are
displayed in Target . Where X is SCSI, Ethernet, Event, Input, Keyboard, or Mouse.
• Tuple 1 and Tuple 2 -- filter based on whether the Target components are physically
part of the selected tuple.
Target Lists the available components on which you can perform commands. When
specifying a command, you
must select a component in Target .
Action Displays the tasks that can be performed on the selected Target .
Operation Displays the components where the selected Action can be performed.
Executed Specifies the IOP from which the Action and Operation should be performed.
This is only available with specific commands.
Parameter Enables you to enter parameters, such as an integer interval value or a true or false
flag. This option is only activated when you select a command that has parameters.
Verbose
Output If selected when executing a command, displays a verbose result of the command.
Confirm
command When selected, Endurance Manager prompts you to either verify or cancel issuing the
selected command. This is set by default for some commands.
Operator
override Enables you to disable an active component that does not have an active redundant
counterpart. This prevents you from accidentally removing your Endurance server or
its redundant components from service.
For example, if IOP1 is unavailable and you issue an IOP2 disable command without
selecting this option, the command is not executed, and a message window reports
that you attempted to disable the only active IOP. As a result, IOP2 is not removed
from the configuration unless you enable operator override.
Apply Executes the selected command.
Close Closes the Display and Control window and returns to the Endurance Main window.
Help Opens Endurance Manager online help.