HP NetServer AA 6200, Руководство администратора

Страница: 100 / 272

5-12 HP Netserver AA Solution Administrator’s Guide
CE Disable Operation
This command disables (removes) the specified CE from the active Endurance server
configuration. For the CE to rejoin the Endurance server, you must enable it using the CE
Enable Operation command.
Warning: This command does not perform a normal Windows operating
system shutdown. As a result, you can lose any data in the
Windows disk cache that has not been written to disk. Therefore,
if only one CE is in operation, use a Windows Shutdown
command instead.
Command CE n Disable Operation From IOP x
Console Syntax
MTCCONS CE n Disable Operation From IOP x -disable_safeguard
Note: The
-disable_safeguard
argument is needed only if the CE
specified is the only active CE.
Variables
n – the ID number of the CE (1 or 2)
x – the ID number of the IOP (1 or 2)
Results
The CE resets, performs a power-on self test, and reboots. The CE
reinitializes, but cannot boot or synchronize with the Endurance server until
you issue a CE Enable Operation command.
To verify that the CE is disabled, on either IOP or the remaining CE, you
can:
• Check the status of the Endurance server in the Endurance Manager
Main window.
• Issue an IOP n Show Configuration command. If the command was
successful, the specified CE is disabled and any associated components
(such as CE n .MIC) are offline .
• Check the Windows Event Viewer for a message that indicates that CE
has been shutdown, disabled, or removed from service.
See Also
CE Enable Operation
CE Remove From Configuration