HP A7533A - Brocade 4Gb SAN Switch Base, Руководство администратора

Страница: 259 / 576

Fabric OS 6.2 administrator guide 257
NOTE: If the default zoning mode is set to All Access and more than 120 devices are connected to the
fabric, you cannot disable the zone configuration. See ” Default zoning mode ” on page 250 for
information about setting this mode to No Access.
The following procedure ends and commits the current zoning transaction buffer to both volatile and
nonvolatile memory. If a transaction is open on a different switch in the fabric when this procedure is run,
the transaction on the other switch is automatically aborted. A message is displayed on the other switches
to indicate that the transaction was aborted.
1. Connect to the switch and log in as admin.
2. Enter the
cfgdisable
command, using the following syntax:
cfgdisable
3. Enter
y
at the prompt.
switch:admin> cfgdisable
You are about to disable zoning configuration. This
action will disable any previous zoning configuration enabled.
Do you want to disable zoning configuration? (yes, y, no, n): [no] y
Deleting a zone configuration
1. Connect to the switch and log in as admin.
2. Enter the
cfgDelete
command, using the following syntax:
cfgdelete " cfgname "
where:
3. Enter the
cfgSave
command to save the change to the defined configuration:
switch:admin> cfgdelete "testcfg"
switch:admin> cfgsave
You are about to save the Defined zoning configuration. This
action will only save the changes on the Defined configuration.
Any changes made on the Effective configuration will not
take effect until it is re-enabled.
Do you want to save Defined zoning configuration only? (yes, y, no, n):
[no]
y
The
cfgSave
command ends and commits the current zoning transaction buffer to both volatile and
nonvolatile memory. If a transaction is open on a different switch in the fabric when this command is
run, the transaction on the other switch is automatically aborted. A message is displayed on the other
switches to indicate that the transaction was aborted.
Clearing changes to a configuration
1. Enter the
cfgTransAbort
command.
When this command is executed, all changes since the last save operation (performed with the
cfgSave
,
cfgEnable
, or
cfgDisable
command) are cleared.
In the following example, assume that the removal of a member from
zone1
was done in error:
switch:admin> zoneremove "zone1","3,5"
switch:admin> cfgtransabort
Viewing all zone configuration information
If you do not specify an operand when executing the
cfgShow
command to view zone configurations, all
zone configuration information (both defined and effective) is displayed. If there is an outstanding
cfgname
The name of the defined zone configuration to be deleted