horsch Leeb 4 AX, Руководство по эксплуатации

Страница: 109 / 161

A port is provided under the spraying mixture
container for draining the technical residual
quantity.
Port with cap
1. Take off the cap.
2. Place a suitable collection vessel under the
port for draining off the remaining quantity.
3. Set the ball valve on the suction side to Fill
spraying mixture container .
4. Activate the PTO-shaft for approx. 10 sec.
to drain the suction connection for filling the
spraying mixture container.
5. Set the ball valve on the suction side to spray-
ing mixture container .
6. Open the drain valve for the residual drain.
7. Set the ball valve on the pressure side to
Circulation/spraying .
8. Close the drain valve again after complete
drainage.
9. Close the port again with the cap each time
it has been opened!
10. Properly dispose of the collected residual
quantity!
Diluted residual quantity
Perform the dilution and spraying out of residual
quantities from the spraying mixture container
after the end of spraying operation as follows:
Procedure
1. Spray the undiluted residual quantity from the
spraying line on an untreated residual area.
2. Dilute the residual quantity in the spraying
mixture container with 200 litres of fresh
water.
3. Spray the diluted residual quantity also on an
untreated residual area.
4. Repeat steps 2 and 3 for a second (if neces-
sary a third) time.
Diluting the residual quantity
1. Set the ball valve on the suction side to fresh
water tank .
2. Set the ball valve on the pressure side to
Agitator .
3. Switch on the PTO-shaft.
4. Recirculate the desired amount of fresh water
into the spraying mixture container.
5. Switch off the PTO-shaft again.
6. Set the ball valve on the suction side to spray-
ing mixture container .
7. Set the ball valve on the pressure side to
spraying .
In case of multiple nozzle bodies all existing
nozzles must be opened for cleaning. There
is danger of deposits if this instruction is
not followed!
103