SPRAY
SPRAY
EarthWay
EarthWay
®
®
Congratulations on the purchase of this new EarthWay product. Please call us if you have any difficulty with assembly
or operation of this sprayer. We can be reached via the telephone at 800-294-0671 or 574-848-7491 Monday—Friday
9:00am ~ 4:00pm or visit us online at www.earthway.com This sprayer comes with lifetime technical support, email us at
HELPFUL HINTS: READ THE DIRECTIONS BEFORE ASSEMBLY
THIS SPRAYER COMES PARTIALLY ASSEMBLED, REQUIRING YOU TO INSTALL THE WHEELS, HANDLE ASSEMBLY,
SPRAY GUN HOLDER, AND CONTROL ROD. IT SHOULD TAKE APPROXIMATELY 15 MINUTES WITH THE USE OF TWO
7/16” WRENCHES AND 1 PAIR OF PLIERS.
5
Your sprayer is designed to be pushed at three miles per hour, which is a brisk walking speed. Slower or faster speeds
will change the spray patterns & volumes.
5
Clean your sprayer tank thoroughly after each use. Wash with clean water and push sprayer a several feet to evacuate any
residual materials until you see clean water in a safe area as described in the chemical supplier directions.
5
Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.
5
Check all hose connections regularly to ensure they remain tight.
5
If unit fails to spray on initial use, loosen the yellow cap on the DCV slightly, then retighten.
5
Coat all metal surfaces (inside & out) with WD-40 to help prevent corrosion.
S25
SPRAY
PRO
PUSH SPRAYER
ASSEMBLY and OPERATING INSTRUCTIONS
Pt.# 52230 MKII
PAGE 1
1. Open carton and remove the Handles, Control Rod, Handle Shaft
assembly, hardware pack, wheels, and the S25 from carton.
Rotate wheel
to help
replace pins
Slide pins into hub
then spray with WD-40
now slide wheel in fully and
add cotter pin
1” Cotter Pin
Coast Wheel
Drive Wheel
1” Cotter Pin
2. Turn the S25 upside-down on to the tank.
SLIDE
Gearbox
Axle Assembly
Lower
Handle
Frame
Brace
Cross Brace
3. Ensure that the axle bearings are pushed into the axle bushing on both sides as shown
at the right. Install the Coast wheel (this wheel does not have the steel ring on the inside
hub as shown below) on to axle using the cotter pin hole closest to edge of the axle. Insert
1” cotter pin through the axle and bend with pliers to prevent pin from falling out.
4. Install the flat washer (included with the 3 knurled
dowel pins) onto the axle and slide to the lower
handle. Next, position the Drive wheel onto the axle
about 2 inches, now install 3 knurled
dowel pins into each pin slot located in
the hub by sliding 1 dowel pin between
the hub and the axle as shown below,
coat the knurled pins with WD-40 or a
light oil, finish by sliding the wheel tight
against the lower handle. Now insert 1”
cotter pin through axle, bend with pliers
to prevent cotter pin from falling out.
Cotter Pin
Locations
Steel Ring
Flat Washer
