horsch Leeb 4 AX, Руководство по эксплуатации

Страница: 122 / 161

Maintenance location Work instructions Interval
Drawbar eye
Wear
a
h
b
¾
Replace the component concerned if one of the wear limits
has been exceeded or fallen short of (workshop work):
40 h
Designation
Nominal
dimension (mm) Wear dimension (mm)
ø eye a 40 42.5
Width of ring b 30 27.5
Height of ring h 42 39.5
Designation
Nominal
dimension (mm) Wear dimension (mm)
ø eye a 50 52.5
Width of ring b 33 31.5
Height of ring h max. -1.5
Folding boom
Complete machine Check for apparent faults daily
Folding boom / parallelogram Visual inspection of folding joints for zero clearance,
apparent faults and wear. In case of play or lose
components, have faults corrected by HORSCH Customer
Service.
50 h
Folding boom Check setting yearly
Wheels / brakes
Undercarriage / wheels Check for damage (cracks, etc.) daily
Check fastening / retighten wheel nuts - see above see above
Check air pressure daily
Bearing of wheel hub Check clearance and adjust if necessary (must only be
carried out by an expert workshop)
200 h
Brake system Check condition and function daily
Drain air reservoir daily
Check brake lines and hoses for damages, crushing points
and kinks
daily
check for leaks 200 h
Check pressure in air reservoir 200 h
Check pressure of brake cylinders 200 h
Check joints on brake valves, brake cylinders and brake
linkage
200 h
Check brake settings on folding boom actuator 200 h
Inspection of brake lining 200 h
Clean the pipe filter 200 h
Check brake settings yearly
Brake drum Check for contamination yearly
Autonomous hydraulic system with PTO-shaft drive
Oil tank Change hydraulic oil and filter yearly
Gearbox Oil change yearly
Propshaft
Propshaft Clean propshaft and check drive shaft for damages yearly
116