Honey Bee Grain Belt Plus, Руководство пользователя

Страница: 89 / 179

Honey Bee Manufacturing Ltd.
Grain Belt Plus Header – Owner's Manual
Maintenance
Finger Auger
High wear parts such as the finger guides should be checked carefully. Remove the
inspection cover on the drum to examine the inside. Check the finger bearings. Each one
should be free of any binding. Examine the rivet or roll pin in the finger bearing. It must be
tight. If roll pin is working its way out, install a wire in the center of the roll pin.
Hydraulic System
Check for leaks at pump, motors, hoses, steel lines, and cylinders. Tighten, repair, or replace
as required.
Check pressure gauges for proper operating pressure.
Crop Dividers and Crop Deflectors
Check for damage; abrasive wear on the shoe of the crop divider. Repair as required.
Check for stress cracks. Repair as required.
Cutting System
Check daily, and clean all built-up straw, dirt and debris from under the feather plates and the
sensor paddles for the reel-height control
Check knife head and knife drive bearings. Grease as required.
Check all cutting parts carefully for damage and wear. Worn knives and guards can cause
higher cutting pressures and increased stalling. Sickle sections are considered worn if the
cutting edges are chipped, broken or dull.
The cutting edge of the guard gets rounded and wider as the guards wear. When the gap is
approximately the thickness of two sickle sections, it is time to replace the guards.
Check knife back and bridge rollers.
Check connector bar joints. The center of the connector bar should be directly under the
middle of a sickle section.
Oil knife and guards for storage.
Decks
See deck maintenance in the Draper section of this manual.
Drive Shaft
Check each yoke and cross kit for wear. Replace as required.
Grease slide tubes, yokes and shield bearing.
Rev. 07 - 07/29/08 87