Honey Bee Grain Belt Plus, Руководство пользователя

Страница: 152 / 179

Honey Bee Manufacturing Ltd.
Grain Belt Plus Header – Owner's Manual
Scenario 1:
The flotation restrainer pins are set too high and need to be either lowered, or removed
altogether and placed into the storage hole, to allow a full range of flotation. (See Illustration
13-20: Header Subframe - Left Hand Side.)
To change the position of the flotation restrainer pins, refer to the “Header Flotation Restrainer
Plate” subsection in the LEVELING chapter of this manual.
Scenario 2:
The link arm is set up too short (not pushed far enough in to the clevis pin slot). The clevis
end of the sensor rod must be pushed to the rear, into the slot of the sensor arm. If it is not,
you will get a very short or small voltage range.
To change this distance, see Illustration 13-14: Clevis Pin Adj. on page 145, and proceed as
follows:
1. Loosen the link arm set screw, located at the pivot.
2. Slide the clevis end of the link arm as far back as possible into the slot of the sensor
arm while in its mid (horizontal) position.
It is important to keep the rod and sensor arm in line with each other when
performing this procedure. If they are not in line when securing the clevis pin
into the sensor arm slot, the assembly will bind as it approaches horizontal.
3. Re tighten the rod locking coupler nut.
Rev. 07 - 07/29/08 150
Illustration 13-20: Header Subframe - Left Hand Side
Restrainer Plate
Pin Storage
Location