Honey Bee Grain Belt Plus, Руководство пользователя

Страница: 156 / 179

Honey Bee Manufacturing Ltd.
Grain Belt Plus Header – Owner's Manual
Sensitivity:
The sensitivity of the control system can be adjusted using the multi-position rotary switch on
the console. This may be used by the operator to adjust for different machine response, or
crop conditions. The current sensitivity is shown in the upper right of the display.
High sensitivity will cause the reel to react more quickly and also cause the reel to move a
greater distance. If the sensitivity is too high it will cause the reel to move too much or start
hunting.
Low sensitivity will take greater cutter bar movement to move the reel and will move the reel
less distance. If the sensitivity is too low, the reel fingers may be cut off by the knife.
When operating the reel close to the knife, a higher sensitivity will cause the reel to respond
more quickly to small movements in the knife. Similarly, when the distance between the reel
and knife can be set at a higher value, the sensitivity may be reduced, allowing the sensors to
tolerate greater movement in the knife before responding.
Setting the Automatic Reel Height (Safety Set Point)
The Safety Set Point can be programmed when the control system is in Manual Mode.
To program the Safety Set Point, select Manual
Mode using the Control Mode button.
1. Use the combine controls to place the reel at a safe
distance from the cutter bar, place the header at cutting
height, then press and hold the Set button until the
display shows the message, "Set Point Stored."
2. Select Automatic Mode, using the Control Mode button
to return to normal operation.
3. Use the combine controls to raise the reel slightly until
the "Block" light goes out.
4. If the Automatic Reel Height control operation is not
satisfactory, refer to Adjusting Cutter Bar Sensors for
Reel Height Control.
CAN Communication:
The cab console and the controller use an advanced system called CAN to communicate.
When CAN communication is operating properly, the “Comm Active” indicator will be lit on the
cab console. If the communication link fails, this LED will be extinguished. Depending on the
type of failure, a diagnostic message may also be shown on the display.
Rev. 07 - 07/29/08 154
Illustration 13-26: Cab
Console - Reel Height
Set
Control
Mode