Honey Bee Grain Belt Plus, Руководство пользователя

Страница: 54 / 179

Honey Bee Manufacturing Ltd.
Grain Belt Plus Header – Owner's Manual
Leveling & Table Height Adjustment
Reducing the amount of exposed threads at the
back of the adjuster bolts will lower the table,
Increasing the amount of exposed thread will raise
table.
To level the table, adjust the amount of exposed
thread depending on which side needs to be raised
or lowered.
To turn the adjuster bolts, lower the
table to the ground. This will take
weight off the bolts making them
easier to turn.
Refer to the photo on the right. Decreasing the
number of threads exposed above the nut will
increase header floatation, and improve the
operation of the header height control system.
To lower the cutter bar relative to the sub-frame, extend both adjuster bolts. This adjustment
will provide more clearance between the sub-frame and the ground; and will also provide
more clearance between the feeder deck and the ground. This setting will bring the cutter bar
closer to the ground. *(See Examples A, B, C and D)
Avoid a condition where no threads are exposed behind the adjusting nut. In
this case, the threads may disengage from the lift link, causing the table to
drop suddenly.
In addition, care must be taken when lengthening the adjusting bolts, as this
action will decrease the size of the opening leading to the finger auger. The
finger auger is stationary in the sub-frame, and as the table lowers with the
adjusting bolts, the hydraulic lines under the upper tube get closer to the
fingers in the auger. To see that the fingers do not contact the hydraulic lines,
disconnect the drive line, lift the finger auger and rotate the drum while
checking the clearance.
Rev. 07 - 07/29/08 52
Illustration 4-2: Header Tilt - Right View