Honey Bee Grain Belt Plus, Руководство пользователя

Страница: 167 / 179

Honey Bee Manufacturing Ltd.
Grain Belt Plus Header – Owner's Manual
Problem Possible Cause Solution
Knife
Knife stalls easily. Crop too heavy for ground
speed.
Knife speed not set properly.
Low hydraulic pressure at knife
motor.
Bent guards or cutter bar.
Dull or wrong type of sections.
Faulty knife drive.
Seized knife head bearing.
Knife head out of alignment.
Unloaded system pressure too
high.
Relief valve stuck open.
Reduce ground speed.
Adjust.
Check system pressure.
Repair or replace.
Replace sections.
Check for loose crank shaft.
Replace.
Adjust alignment on knife.
Check for faulty draper motor.
Check that each draper is
running freely.
Remove and clean cartridge.
Knife running too
slow or too fast.
(<580/ >600 rpm) Low hydraulic oil.
Relief valve stuck open.
Worn pump or knife motor.
Pump set incorrectly for
combine. Add oil
Clean/ replace cartridge.
Repair or replace.
Adjust pump setting.
Knife will not run. Low hydraulic oil.
Faulty drive motor.
Faulty knife drive.
Faulty hydraulic pump.
Cutter bar jammed.
Add oil. Determine cause of
low oil.
Repair or replace motor.
Repair or replace.
Repair or replace.
Check for damaged guards or
sections.
Excessive Vibration. Knife running too fast.
Loose bearings in drive.
Loose knife head bolts. Check speed. (580-600 rpm)
Replace bearings.
Tighten.
Rev. 07 - 07/29/08 165