Honey Bee Grain Belt Plus, Руководство пользователя

Страница: 120 / 179

Honey Bee Manufacturing Ltd.
Grain Belt Plus Header – Owner's Manual
Installing Draper motor
1. Clean motor shaft and hub of drive
roller. Apply anti-seize to shaft.
2. Insert key in motor shaft.
3. Ensure that key in motor shaft is
aligned with key way in drive roller,
and fully insert motor shaft into hub.
4. Tighten hex bolts to 65 ft-lbs.
Do not use a hammer on rear end of the motor to make it fit. Impact damage
of this type to the motor will void the warranty.
Use a soft block or rubber hammer to apply force to end of the motor. Rocking
motor up and down or side to side may also help.
Year – End Draper and Deck Maintenance
1. Remove draper connector bar.
2. Remove draper – clean draper of debris, both sides.
3. Clean debris from rollers.
4. Clean debris from deck channels and runners.
5. Check and bend down corners of deck runners so draper does not get caught.
6. Clean adjusters; lubricate guide tubes and adjuster tubes. Adjusters should be able to
move freely inside the guide tube.
7. Check idler roller bearings, they should spin freely.
8. Check driver roller bearings
9. Check bearing stubs.
10. If storing header outside with draper installed, position the connector bar on the
underside to allow water to drain from decks. Water build up may cause stretching.
11. Repeat these steps on the feeder deck.
Rev. 07 - 07/29/08 118
Illustration 10-27: Draper Motor - Key