Honey Bee Grain Belt Plus, Руководство пользователя

Страница: 34 / 179

Honey Bee Manufacturing Ltd.
Grain Belt Plus Header – Owner's Manual
Remember to always think safety and work safely!
Combine Preparation
1. Remove the factory pickup or auger header from the combine as outlined in your
Owners/ Operators manual, supplied by the combine manufacturer.
2. Check the feeder house front and top for straw and chaff. Clean all contact areas
thoroughly.
3. Check all locking mechanisms and/ or lock pins on feeder house of combine to ensure
they are working properly and will not interfere with the initial mounting of the Grain
Belt Plus header onto your combine.
4. Ensure the Combine Hydraulic Reservoir Integration hose is properly installed.
5. Check for leaks and/ or loose fittings on hydraulic lines (hoses) which attach to the
header. Repair if necessary.
Grain Belt Plus Header Preparation
1. Check the feeder house adapter area on the Grain Belt Plus header for any
obstructions.
2. Be sure the rotating pump mount and attached hoses are clear of the feeder house
adapter opening. Slide the telescoping drive shaft back as far as possible and secure
into transport cradle. If necessary, lift and lock the rotating pump mount into transport
position so it does not interfere with the feeder house as you drive the combine
forward.
3. Check hydraulic hoses to be sure the couplers match those on the combine.
Some types of couplers may not be supplied with the Grain Belt Plus Header.
4. The header should be placed on flat, hard and level ground.
5. If the transport package was not purchased, refer to the TRANSPORT TRAILER
MANUAL for Mounting & Dismounting instructions. (*Note: 30 ft and 36 ft models are
available with the option of integral transport package or a transport trailer. 42 ft and 45
ft models are available with a storage axle on a transport trailer.
6. If the optional transport system or storage axle was purchased, ensure that the header
is sitting level prior to hookup by adjusting the hitch jack up or down as needed.
7. Install the crop dividers and crop divider pipes onto the ends of the table. These items
are not installed at the factory. Operators should be aware of the greater transport
width of the table with these items installed, and should check local regulations.
Rev. 07 - 07/29/08 32