Honda SH300I 2006, Руководство пользователя

Страница: 444 / 511

ELECTRIC STARTER
21-4
TROUBLESHOOTING
Starter motor does not turn
1. Standard Inspection
Check the following:
– Battery condition
– Burned fuse
Are the above items in good condition?
YES – Replace or repair the malfunction part(s).
NO – GO TO STEP 2.
2. Starter Relay Operation
Retract the sidestand.
Turn the ignition switch "ON" with the engine stop switch at " ".
Squeeze the rear brake lever fully and push the starter switch.
You should hear the relay "CLICK" when the starter switch is depressed.
Is the "CLICK" heard?
YES – GO TO STEP 3.
NO – GO TO STEP 5.
3. Starter Motor Inspection
Turn the ignition switch "OFF".
Apply battery voltage to the starter motor directly and check the operation. (A large amount of cur-
rent flows, so do not use a thin wire.)
Does the starter motor turn?
YES – GO TO STEP 4.
NO – Inspect the starter motor (page 21-9).
4. Starter Relay Continuity Inspection
Check the starter relay for continuity (page 21-15).
Is there continuity?
YES – • Loose or poorly connected starter motor cable.
• Loose or poorly connected starter relay connector terminal.
• Open circuit in starter motor ground cable.
• Open circuit in Red wire between the battery and starter relay.
• Open circuit in Red wire between the starter relay and starter motor.
NO – Faulty starter relay.
5. Starter Relay Coil Power Input Line Inspection
Check the starter relay coil power input line inspection (page 21-14)
Is the power input line normal?
NO – • Loose or poorly connected connector.
• Inspect the starter switch (page 22-18).
• Inspect the inhibitor switch (page 22-19).
• Open circuit in Green/Yellow wire between the starter relay and starter switch.
• Open circuit in Yellow/Green wire between the starter switch and inhibitor switch.
• Inspect the engine stop relay (page 6-67).
YES – GO TO STEP 6.