Honda SH300I 2006, Руководство пользователя

Страница: 280 / 511

FINAL REDUCTION
12-10
Be careful not to
damage the final
reduction case mat-
ing surface.
Drive the final gear shaft bearing out of the reduc-
tion case.
Remove the driveshaft and countershaft bearings
using the special tools.
Apply engine oil to the bearing cavity.
Drive new bearings into the final reduction case with
the marked side facing up until it is fully seated, using
the special tools.
Apply engine oil to lips and outer surface of a new
final gear shaft oil seal.
Install the oil seal with the flat side facing down
(bearing side) so that the depth from the final reduc-
tion case surface is 0.5 – 1.0 mm (0.02 – 0.04 in).
Apply grease to a new final shaft dust seal lip.
Install the dust seal so that the depth from the final
reduction case surface is 3.0 – 3.5 mm (0.12 – 0.14
in).
Install the side collar into the dust seal.
TOOLS:
Driveshaft bearing:
Bearing remover head, 15 mm 07936-KC10200
Bearing remover shaft
07936-KC10100
Remover weight 07741-0010201
Countershaft bearing:
Bearing remover head, 14 mm 07WMC-KFG0100
Bearing remover shaft
07936-KC10100
Remover weight 07741-0010201
BEARING REMOVER
WEIGHT
COUNTERSHAFT
BEARING
FINAL GEAR
SHAFT BEARING
DRIVESHAFT BEARING
TOOLS:
Driveshaft bearing:
Driver 07749-0010000
Attachment, 42 x 47 mm 07746-0010300
Pilot, 15 mm 07746-0040300
Countershaft bearing:
Driver 07749-0010000
Attachment, 22 x 24 mm 07746-0010800
Pilot, 14 mm 07746-0041200
Final gear shaft bearing:
Driver 07749-0010000
Attachment, 52 x 55 mm 07746-0010400
Pilot, 25 mm 07746-0040600
FINAL GEAR
SHAFT BEARING
COUNTERSHAFT BEARING
DRIVESHAFT
BEARING
DRIVER
/PILOT
ATTACHMENT
0.5 – 1.0 mm
(0.02 – 0.04 in)
OIL SEAL
3.0 – 3.5 mm
(0.12 – 0.14 in)
DUST SEAL
SIDE COLLAR