Honda SH300I 2006, Руководство пользователя

Страница: 91 / 511

MAINTENANCE
4-17
FINAL DRIVE OIL
OIL LEVEL CHECK
Place the scooter on its centerstand on a level sur-
face.
Remove the oil check bolt.
Check whether the oil flows out from the check bolt
hole.
If the oil level is low (that is not flow out), add the
recommended oil as follows:
Remove the oil filler bolt.
Pour the recommended oil through the oil filler hole
until oil flows out from the check bolt hole.
Install the check bolt (M8 x 25) with a new sealing
washer and tighten it.
Install the filler bolt (M8 x 12) with a new sealing
washer and tighten it.
OIL CHANGE
Remove the oil check bolt and drain bolt, slowly
turn the rear wheel and drain the oil.
After the oil is completely drained, install the drain
bolt (M8 x 12) with a new sealing washer and
tighten it to the specified torque.
Fill the final reduction case with recommended oil
up to the correct level (page 4-17).
RECOMMENDED FINAL DRIVE OIL:
Honda "4-stroke motorcycle oil" or an equivalent
API service classification: SG or higher (except oils
labeled as energy conserving on the circular API
service label)
Viscosity: SAE 10W-30
JASO T 903 standard: MA
Be careful not to
misplace the check
bolt and filler bolt.
TORQUE: 13 N·m (1.3 kgf·m, 10 lbf·ft)
TORQUE: 13 N·m (1.3 kgf·m, 10 lbf·ft)
FILLER BOLT
CHECK BOLT
SEALING WASHER
SEALING WASHER
Be careful not to
misplace the check
bolt and drain bolt.
TORQUE: 13 N·m (1.3 kgf·m, 10 lbf·ft)
OIL CAPACITY:
0.28 liter (0.30 US qt, 0.25 Imp qt) after draining
0.30 liter (0.32 US qt, 0.26 Imp qt) after disassem-
bly
CHECK BOLT
DRAIN BOLT
SEALING WASHER