Honda CBF600N, Руководство по обслуживанию, Страница: 276 / 620

CYLINDER HEAD/VALVES
8-18
Measure and record each valve guide I.D.
Subtract each valve stem O.D. from the correspond-
ing guide I.D. to obtain the stem-to-guide clearance.
If the stem-to-guide clearance is out of standard,
determine if a new guide with standard dimensions
would bring the clearance within tolerance. If so,
replace any guides as necessary and ream to fit.
If the stem-to-guide clearance exceeds the service
limit with the new guides, replace the valves and
guides.
VALVE GUIDE REPLACEMENT
Chill the replacement valve guides in the freezer
section of a refrigerator for about an hour.
Heat the cylinder head to 100 – 150
°
C (212 – 300
°
F)
with a hot plate or oven.
To avoid burns, wear heavy gloves when handling
the heated cylinder head.
Support the cylinder head and drive out the valve
guides from combustion chamber side of the cylin-
der head.
Drive in the guides to the specified depth from the
top of the cylinder head.
Let the cylinder head cool to room temperature.
Use cutting oil on
the reamer during
this operation.
Ream the new valve guides after installation.
Insert the reamer from the combustion chamber
side of the head and also always rotate the reamer
clockwise.
Clean the cylinder head thoroughly to remove any
metal particles.
Reface the valve seat (page 8-20).
SERVICE LIMITS: IN/EX: 4.04 mm (0.159 in)
SERVICE LIMITS:
IN: 0.075 mm (0.0030 in)
EX: 0.085 mm (0.0033 in)
Reface the valve
seats whenever the
valve guides are
replaced (page 8-
20).
Do not use a torch
to heat the cylinder
head; it may cause
warping.
TOOL:
Valve guide driver
07GMD-KT70100
VALVE GUIDE DRIVER
SPECIFIED DEPTH:
IN: 17.1 – 17.4 mm (0.67 – 0.69 in)
EX: 13.3 – 13.6 mm (0.52 – 0.54 in)
TOOL:
Valve guide driver
07GMD-KT70100
VALVE GUIDE DRIVER
TOOL:
Valve guide reamer, 4.008 mm
07MMH-MV90100
VALVE GUIDE REAMER
Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
email: info@motomatrix.co.uk