Henny Penny PFE-591, Руководство оператора

Страница: 67 / 73

Model PFE- 591
4-2. ERROR CODE TABLE In the event of a control system failure, the digital
display shows an error message. These messages
are coded: “E4”, “E5”, “E6”, “E10”, “E15”, “E-25”,
“E-26”, “E-27”, “E41”, “E46”, “E47”, “E48”, “E70A”
& “B” and “E92”. An alarm sounds when an error
code is displayed, and to silence this alarm, press any
button.
DISPLAY CAUSE PANEL BOARD CORRECTION
“E-4” Control board Turn switch to OFF position, then turn switch back ON;
overheating if display shows “E-4”, the control board is getting too hot;
check the louvers on each side of the unit for obstructions;
check cooling fan, if present
“E-5” Shortening Turn switch to OFF position, then turn switch back to ON;
overheating if display shows “E-5”, the heating circuits and temperature
probe should be checked
“E-6 A” Temperature Turn switch to OFF position, then turn switch back to ON;
probe open if display shows “E-6”, have the temperature probe checked
“E-6 B” Temperature Turn switch to OFF position, then turn switch back to ON;
probe shorted if display shows “E-6” have the temperature probe checked
“E-10” High limit Reset the high limit by manually pushing up on the reset
button; if high limit does not reset, high limit must be replaced
“E-15” Drain switch Close drain, using the drain valve handle; if display still
failure shows “E-15”, have the drain microswitch checked
“E-25” Heat amps too Heating elements drawing too much current; have heat circuit
high checked
“E-26” Heat amps locked Heating elements are drawing current when controls are not
on calling for heat; have controls and heat circuit checked
“E-27” Heat amps too low Heating elements current is lower than expected; have heat circuit
checked
403 4-2