Henny Penny PFE-591, Руководство оператора

Страница: 38 / 73

Model PFE- 591
3-11. FILTER PUMP MOTOR
The filter pump motor is equipped with a manual reset button,
PROTECTOR-MANUAL
located on the rear of the motor, in case the motor overheats. If
RESET
motor won’t run, wait about 5 minutes before attempting to reset
this protective device to allow motor to cool. Remove the access
panel on the left side panel of the unit to reset the button. It takes
some effort to push the reset, and a screwdriver can be used to
help reset the button.
To prevent burns caused by splashing shortening, turn
the unit’s main power switch to the OFF position before
resetting the filter pump motor’s manual reset protec-
tion device.
3-12. CLEANING THE FRYPOT
After the initial installation of the fryer, as well as before every
change of shortening, the frypot should be thoroughly
cleaned as follows:
1. Turn the COOK/PUMP switch to OFF, and unplug unit
from wall receptacle.
Moving the fryer or filter drain pan while containing
hot shortening is not recommended. Hot shortening can
splash out and severe burns could result.
The filter drain pan must be as far back under fryer
as it will go, and the cover in place. Be sure the hole in
the cover lines up with the drain before opening the
drain. Failure to follow these instructions causes
splashing of shortening and could result in personal
injury.
2. If hot shortening is present in the frypot, it must be drained by
slowly pulling the drain handle out towards you.
3. Close the drain valve and discard the shortening.
4. Raise lid, remove the racks and carrier from lid, and tilt lid
back, so that the lid won’t interfere with cleaning.
Henny Penny has the following cleaners available:
Foaming Degreaser - Part no. 12226
PHT Liquid Cleaner - Part no. 12135
PHT Dry Powder Cleaner - Part no. 12101
See your local distributor for details.
3-22 705