Henny Penny PFE-591, Руководство оператора

Страница: 30 / 73

Model PFE- 591
3-7. BASIC OPERATION 4. Allow fryer to heat until illuminates.
(Continued)
Bypass Melt Cycle, if desired, by pressing a product button
and holding it for five seconds. The display shows
“EXIT MELT? 1=YES 2=NO”. Press to exit melt.
Do not bypass the Melt Cycle unless enough shortening
has melted to completely cover all of the heating
elements. If the Melt Cycle is bypassed before all
heating elements are covered, excessive smoking of
shortening, or a fire could result.
The heat cycles on and off about 10 degrees before the
setpoint temperature, to help prevent overshooting the
setpoint temperature. (proportional control)
Once out of the Melt Cycle, flashes until 5° before setpoint
temperature is reached. Then illuminates and the selected
product shows in the display.
5. Before loading product onto the racks, lower the racks
into the hot shortening to prevent the product sticking to
the racks.
6. Slide racks of breaded product into carrier on the lid,
starting with the bottom tier, to avoid damaged product.
7. Lower and lock the lid, and press .
A different product can be selected during the first minute of
cooking, in case the wrong Product Button was pressed. To
check the shortening temperature press or to stop a
cook cycle, press .
8. At the end of the cycle, the pressure vents automatically and
an alarm sounds, while the display shows “DONE”. Then,
press .
3-14 703