Heicko ERSDC1038-02, Руководство пользователя

Страница: 36 / 44

-34-
HRSDC_ERSDC10.12_EN
x2 x2
Important! - Please note
• For adjusting the limit positions the motor needs to be connected to an emitter.
• Both limit positions must be set as described (coherently, in one operation).
• If a correction of the limit positions is required, please proceed as described at 8.5.3.
8.5 Adjustment of the limit positions
8.4 Change of rotation direction - 2 options
P2
Press P2
for 1 second
Press P2
for 1 second
Press „Down“
for 1 second
P2
Press P1
for 2 seconds
Press P1
for 6 seconds
b)
a)
x1 x1 x1 x1 x1 x1 x6
8.5.1 Limit setting mode
P2
Press P2
for 1 second
P2
Press P2
for 1 second
Press „Up“
for 1 second
x1 x1 x4 x1 x1 x1
x1 x5
Move to your
desired position
Press „Stop“
for 1 second
Move to your
desired position
8.5.2 Setting of the upper and lower limit position of motor type ERSDC1040-06
Press „Up“
for 1 second
Press „Stop“
for 5 seconds
Press „Down“
for 1 second
Press „Stop“
for 1 second Press „Stop“
for 5 seconds
If you are in the limit setting mode and no command is given within 2 minutes,
the motor will automatically exit the mode.
The hanging can be moved to the previously set limit position by pressing the
P1 multi-function button. Pressing it again will stop the motor.
8.6 Setup / Delete intermediate stop function
x1 x5
8.5.3 Correcting existing limit positions
Press "Up" and
"Down" for 5
seconds
+
To change the existing limit position, the hanging must be at the respective limit position.
x1 x4
Adjustment of the limit positions
press for at least 2 seconds for a
continuous movement
oder
Press „Stop“
for 5 seconds
x1 x5
Note! - This function is not
available when using the
controls HD05B, HD15BT,
HR120033WA, HR120038G2,
HR1200-SUN-G2 and
HR1300-WIND-G2!
Move to your
desired position
P2
To get to the intermediate
position please press the
"Stop" button for 2 seconds.
Press „Stop“
for 1 second Press „Stop“
for 1 second
Press P2
for 1 second
Press „Stop“
for 1 second
Important! - To set the intermediate stop function, the limit positions must be already set.
x1 x3 x1 x1 x1 x1