Heicko ERSDC1038-02, Руководство пользователя

Страница: 30 / 44

-28-
HRSDC_ERSDC10.12_EN
0
1
x3 x3
6.5 Change of rotation direction - 2 options
0
1
Press P1
for 10 seconds
P2
Press P2
for 1 second
Press P2
for 1 second
Press „Down“
for 1 second
P2
Press P1
for 2 seconds
b)
a)
x1 x1 x1 x1 x1 x1 x6
6.6.1 Limit setting mode
P2
Press P2
for 1 second
P2
Press P2
for 1 second
Press „Up“
for 1 second
x1 x1 x4 x1 x1 x1
x1
x5
Move to your
desired position
Press „Stop“
for 1 second Move to your
desired position
6.6.2 Setting of the upper and lower limit position of motor type ERSDC3808-35
Press „Up“
for 1 second
Press „Stop“
for 5 seconds
Press „Down“
for 1 second
Press „Stop“
for 1 second Press „Stop“
for 5 seconds
If you are in the limit setting mode and no command is given within 2 minutes,
the motor will automatically exit the mode.
The hanging can be moved to the previously set limit position by pressing the P1
multi-function button. Pressing it again will stop the motor.
6.7 Setup / Delete intermediate stop function
x1 x5
6.6.3 Correcting existing limit positions
Press "Up" and
"Down" for 5
seconds
+
To change the existing limit position, the hanging must be at the respective limit position.
x1 x4
Adjustment of the limit positions
press for at least 2 seconds for
a continuous movement
or
Press „Stop“
for 5 seconds
x1 x5 Note! - This function is not
available when using the
controls HD05B, HD15BT,
HR120033WA, HR120038G2,
HR1200-SUN-G2 and
HR1300-WIND-G2!
Important! - Please note
• For adjusting the limit positions the motor needs to be connected to an emitter.
• Both limit positions must be set as described (coherently, in one operation).
• If a correction of the limit positions is required, please proceed as described at 6.6.3.
6.6 Adjustment of the limit positions
Move to your
desired position
P2
To get to the intermediate
position please press the
"Stop" button for 2 seconds.
Press „Stop“
for 1 second Press „Stop“
for 1 second
Press P2
for 1 second
Press „Stop“
for 1 second
Important! - To set the intermediate stop function, the limit positions must be already set.
x1 x3 x1 x1 x1 x1