Revision C • 10/07
H
A
R
R
I
S
C
O
R
P
O
R
A T
I
O
N
2-30
2 Installation
Buttoncap Lenses
All buttoncaps on the RMX
digital are shipped
from the factory with laser-etched lenses with stan-
dard labeling (as shown on pages 3-2 and 3-4).
Laser etching ensures each buttoncap’s labeling
withstands millions of button pushes.
Selected buttoncaps feature removable lenses for
field installation of custom printed inserts. Two
sizes of clear lenses and inserts are available: large,
for the Off buttons on the Dual Fader panels and
the two talk buttons on the Monitor Control panel;
and small, for the Talkback buttons on the Dual
Fader panels and for the twenty-one selector but-
tons on the Monitor Control panel.
Clear lenses for both size buttoncaps are in-
cluded in the 76-1400 install kit. They hold printed
inserts in place on the removable lens buttoncaps.
Additional clear lenses of both sizes are available
in the 76-1403 kit for the Monitor Control panel
(twenty-one small and two large lenses) and the
76-1404 kit for the Universal Dual Fader Input
panel (two large and two small lenses).
A Microsoft® Word template file (71-1961,
shown in the right column) is available on the CD-
ROM or on the Harris FTP site (see page 5-1 for
access info). It is used with the 80-1961 clear in-
sert sheet to create custom lens labels. The 80-
1961 sheet, with diecut inserts for both small and
large lenses, can be laser or inkjet printed. One
80-1961 sheet is included in the 76-1400 kit.
To use the 71-1961 template, open it up in Word
and replace the default lens text for the number of
buttons that require new labels. Print the template
onto a blank sheet of paper. Note its orientation
as it comes out of the printer. Compare the printed
sheet to the blank 80-1961 sheet by aligning both
sheets over a light. If the lens cutouts match the
printed sheet lens outlines, then delete the out-
lines and instructions on the template (click on
the title block, then click delete, click in the in-
INSERT TEMPLATE, FOR USE ON
BUTTONS WITH REMOVABLE LENS
structions, then click delete). Only the lens text
should remain on the page. Place the 80-1961
sheet into the printer so it is properly oriented
and print the page.
If the printed test sheet does not line up with
the blank 80-1961 sheet, then try printing using
manual feed to adjust the page or adjust the tem-
plate button outlines and text slightly on the page
until they are properly aligned—which, unfortu-
nately, is easier said than done in Word.
LENS REMOVAL
Catch a thumbnail under the top edge of the
lens and pull up to remove it. Place the printed
clear insert into the buttoncap, and then snap a
clear lens onto the buttoncap.
Be sure to retain the factory-etched lenses for
possible future reuse.
Содержание RMXDIGITAL
Страница 2: ...Revision C 10 07 H A R R I S C O R P O R A T I O N ii...
Страница 90: ......
