Harris RMXDIGITAL, Руководство по эксплуатации и техническому обслуживанию

Страница: 27 / 118

Revision C • 10/07
H A R R I S C O R P O R A T I O N
2-11
2 Installation
2
Insert the prepped wire into the contact until
the insulation hits the tool’s wire stop. Hold
the wire in place while squeezing the tool
handles to crimp the contact onto the wire.
The tool handles automatically release and
spring open after the crimp cycle is complete.
Once the contact has been crimped, insert and
lock the contact receptacle into the appropri-
ate connector housing following the pinout
diagrams found on pages 2-10 (for audio) and
2-13 (for logic).
with 3/4" [19.05 mm] of shrink tubing and strip
the insulation from each wire 9/64" [3.57 mm].
CRIMP TOOL OPERATION
A ratcheting AMP crimp tool with contact holder
is included. The tool crimps both the insulation and
wire barrels on the AMP MOD IV receptacle con-
tact in one crimp. To use the ratcheting crimp tool:
1 Insert the contact into the contact holder with
the barrel openings up. Typically the middle
holder is used (for 20 - 24 AWG wire). Flip
the holder up so it magnetically latches against
the crimp tool. The end of the insulation bar-
rel will be about 2 mm from the end of the
die. Close the tool one click (only until the
anvil holds the contact in place, as shown in
the cutaway view, above.)
AMP MOD IV
Contact
Crimp Tool
Crimp Tool — Cutaway View
Anvils
Printed
Side of
Crimp
Tool
Insulation Stop
AMP MOD IV
Receptacle
Contact
Die
Contact Holder,
snapped against
Crimp Tool
Wire
Audio Wire, ready for insertion into an
AMP MOD IV
Receptacle Contacts
Cable ID Tag
3/4” [19.05 mm]
Teflon Sleeving
AMP MOD IV Receptacle Contacts
9/64” [3.57 mm]
Insulation
Crimping Barrel
Properly
Crimped Contact
Wire Crimping
Barrel
Receptacle Contact,
Insertion & Removal Detail
Locking Tab
Locking Tab Slots
Contact Removal Tool