Harris RMXDIGITAL, Руководство по эксплуатации и техническому обслуживанию

Страница: 48 / 118

Revision C • 10/07
H A R R I S C O R P O R A T I O N
3-2
3 Operation
UNIVERSAL DUAL FADER PANEL QUICK GUIDE
Each panel has two identical “channel strips” for independent control of two audio sources. The initial audio
source for each channel strip is set by taking a session file. Sources may then be manually changed on the panel
using the Source Selector and Take button, or by taking a different session file.
FADER SECTION CONTROLS
Input N Input N Input N Input N Input Name D ame D ame D ame D ame Displa ispla ispla ispla isplay — y — y — y — y — The ten-character displays show each
channel’s input source. When the Source Selector is actively being used,
the yellow Next LED lights to indicate the display is now showing an
alternate source name.
S S S S S o u r o u r o u r o u r o u rc cc cce S e S e S e S e Selec elec elec elec electttttor — or — or — or — or — A rotary encoder used to scroll alpha-
numerically through a list of alternate input sources. The source names
shown can be limited by the session file, thus there might only be the
assigned source (plus Silence) shown when this control is used.
T T T T TAKE — AKE — AKE — AKE — AKE — Selects the alternate input source when TAKE is pressed while
the Next LED is lit and the channel is Off. If TAKE is pressed while the
channel is On and the Next LED is lit, the channel “pends” (the On
button flashes) to indicate the new source will be taken as soon as the
channel is turned off.
FCN — FCN — FCN — FCN — FCN — Function button. Press and hold to access special channel strip
features. It is not active at this time.
F F F F Fader — ader — ader — ader — ader — 100mm channel level control with dB indications to show
relative attenuation. For unity gain, set the fader to the red line (-12
dB). This makes a n4 dBu analog input signal appear as a
-20 dBFS (0 VU) signal on the meters.
T T T T TALKB ALKB ALKB ALKB ALKBA A A A ACK — CK — CK — CK — CK — Active (lit) only when a channel strip is set as a Telco
channel during console setup. While pressed, the control room talk mics,
pre-switch and pre-fader, are sent to that Telco channel’s Mix-Minus
output. Up to six faders can be set as Telco channels.
CUE — CUE — CUE — CUE — CUE — When lit, routes pre-fader, pre-switch audio to the cue output
without affecting the on-air signal. On CR mic channels, the cue button
is momentary and the input only goes to the Cue meter display. On all
other inputs it latches (toggle cue on and off) and the input goes to both
the Cue speaker and the Cue meter display.
ON — ON — ON — ON — ON — Press to turn the channel on. The button lights, routing the
audio to the selected buses. Logic control commands may also be
initiated, depending upon session file logic settings for the source.
OFF — OFF — OFF — OFF — OFF — Press to turn the channel off. This removes the audio from all
selected buses except those set for pre-switch operation. Logic control
commands may also be initiated, depending upon session file logic
settings for the source. The button may not light up when pressed since
some inputs may be set to indicate peripheral device status.
FADER
SECTION