888-2406-002
2-7
WARNING: Disconnect primary power prior to servicing.
Installation & Initial Turn-On
To insert the wires into the Wago block, insert a screwdriver into the rectangular slot
above the wire hole and then carefully lift up. This will open the contact inside the Wago
block and the wire can be inserted. Be very careful not to let the wire ends fray as the con-
nectors are very close together and could cause a short. The wire insulation should actu-
ally extend just inside the Wago block hole.
d.
Wire 45 (large orange cable tied up with the transformer) connects to the
feed-thru terminal C3 at the top of the power supply compartment. This is the
52Vdc output from the supply. See Figure 2-2.
e.
The large orange ground wire #46, coming from the top of the rectifier assem-
bly attaches to a ground stud at the top-front edge of the power supply com-
partment. It is located under the shelf which separates the power supply from
the PA compartment just above C3. See Figure 2-2.
f.
Connect the safety ground wire to the stud on the front of the power supply
tray, next to A17TB1, see Figure 2-1.
g.
Tighten the two hold down nuts located on the bottom front corners of the
power supply compartment. Re-install the front cover panel for the power
supply compartment.
Figure 2-2
3-Phase DC Power Supply Connections
Содержание Platinum Z2 CD
