Chapter 2 Quick Start
Configuring and Monitoring
© 2012 Harmonic Inc.
23
ProView 7000 v.2.6, Rev. E
8. To configure the multiplex output:
a
Navigate
Root > Routing and Descrambling > TS (no.) > Output Selection
.
b
Select one or more outputs for the received transport stream (Options: ASI (1–2),
Socket (1–4).) The four sockets are virtual and must be associated to a physical GbE
port.
c
Select
Enable
in each output sub-menu that you select.
NOTE:
In this mode, stream information is not processed and output bit rate is identical to input bit rate.
d
Navigate
Root > Routing and Descrambling > TS (no.) > Activation
.
e
Select
Enable
.
9. To select a program for descrambling:
a
Navigate
Root > Routing and Descrambling > TS (no.) > Descrambling
.
A list of all input programs received displays.
Program name, program ID, program type and program scrambling state display.
b
Select a program for descrambling.
c
Select CAM Selection.
d
Select CAM 1, 2, 3 or 4 to associate the program to it.
Repeat steps 6 to 9 for each multiplex that you wish to use (1–4).
10. Navigate
Root > Decoding > Decoder (no.) > Configuration> Input Selection
.
If you only have a single decoder then their is no
Decoder (no.)
menu.
11. Select a multiplex, 1, 2, 3 or 4, for input.
12. Set the Service Selection Mode:
a
Navigate
Root > Decoding > Decoder (no.) > Configuration > Service Selection Mode
.
If you only have a single decoder then their is no
Decoder (no.)
menu.
b
Select
Program Selection
.
Name
Id
Device
Mode
1 BBC
ID:4301
TV
CAS
2 CNN
ID:4302
TV
CAS
3 IBA 2
ID:4308
AUDIO
FTA
4 MI-TV
ID:8025
TV
FTA
