HARDY MANUFACTURING CO., INC (MODEL LC300, LC500 & LC2500)
PAGE 8
2-3
Hull Removal
After placing your new Hardy Hydronic Heater upon the concrete pad, you are ready to
continue the installation process. There are two methods to gain access to the rear of
the heater to make plumbing and electrical connections.
The first and easiest method is to remove the screw holding the back door panel in
place. The door is easily removed by lifting up on the handle and taking it out. With the
back door removed, using a 5/16” wrench, remove the eight metal screws that are
located below the back door. There are four on each side that hold the panel in place.
After the screws are removed, the panel should come out easily and allow access to
the bottom of the unit to make plumbing and electrical connections.
The second method is the removal of the entire cover. With the back door, the
rectangular piece of stainless, insulation between the fire box and ash doors removed,
and unplug the low water light, the outside cover can be lifted up and off as seen in the
picture. To replace the cover simply repeat these steps in reverse order.
Please see the illustration below for details.
Rear View
Front View
Содержание LC300
