Hardi MUSTANG 3500, Руководство оператора

Страница: 45 / 68

42 HARDI ® MUSTANG 3500 OPERATOR’S MANUAL
Exiting Standard Calibration
Upon completion of the calibration process, exit calibration by simply
turning the rotary dial to any function other than the calibration functions
(RED boxes with white type).
Before beginning operation, refer to Test Speed and Pre-field System
Checkout on pages 43 and 44. This will confirm your calibration
settings, nozzle selection and overall system performance.
Loading Factory Defaults
To load factory defaults, do the following:
1. Turn the rotary switch to the SPEED position.
2. Put the AUTO/MAN/HOLD switch in HOLD.
3. Hold the appropriate RATE key and the “+” switch during power-up.
RATE 1 = English
RATE 2 = Metric
NOTE: Loading factory defaults also clears total counter pair and
F1field counter pair, and blanks the pressure display.
About Test Speed
Test speed is a built-in ground speed simulator that is used in
performing pre-field checks. When a typical operating speed is entered,
the HARDI
® MUSTANG 3500 will respond as if you were actually driving
that speed. It allows you to simulate your spraying application with plain
water, while remaining stationary, so that you can make certain that all
of the equipment is operating properly and that your sprayer can
actually perform the intended application. Test Speed will not
accumulate distance or area.