Hardi MUSTANG 3500, Руководство оператора

Страница: 15 / 68

12
HARDI ® MUSTANG 3500 OPERATOR’S MANUAL
ROTARY SWITCH POSITION
During normal operation, you can view any one of six monitored functions
in the lower right portion of the display by turning the rotary dial to the
appropriate position. The GREEN positions are Operational positions
and the RED positions are Calibration positions. The following describes
the function of each Operational position. The Calibration positions are
discussed in Chapter 7: Calibration.
SPEED:
Displays the ground speed in miles (kilometers) per hour.
FLOW PER MINUTE:
Displays the actual gallons (liters) per minute being applied by the
sections turned on.
OR if the number of nozzles is entered in System
Cal, then this position will display flow per nozzle in ounces per minute
(liters per minute).
TOTAL AREA:
Displays the area covered since the counter was last reset to zero.
This counter does not accumulate area when the console is in HOLD
or if all boom section switches are turned off. If this counter is reset
TOTAL FLOW will reset as well.
FIELD AREA:
Displays the area covered since the counter was last reset to zero.
This counter does not accumulate area when the console is in HOLD
or if all boom section switches are turned off. If this counter is reset
FIELD FLOW will reset as well.
There are 9 field counters (F1-F9). Only the active counter will reset.
To change active counter, console must be in HOLD and rotary
switch in either FIELD AREA or FIELD FLOW. The lower left display
area will display F1-F9. To change use Adjust switch.
TOTAL FLOW:
Displays the total gallons (liters) applied since the counter pair was last
reset to zero. If this counter is reset TOTAL AREA will reset as well.
6