Hardi ALPHA 2000, Инструкция

Страница: 29 / 52

29
ALPHA
Inner section alignment (GVA)
1. Loosen the counter nut A and adjust the eye B until
the boom is aligned with the centre section.
A
B
Inner / outer sections alignment (GVA)
1. Loosen the counter nut A and screw in the stop bolt B .
2. Unfold the boom completely.
3. Forward/backward adjustment: loosen counter nuts
C
and turn the rigging screw D until the inner and outer
sections are aligned.
4. Up / down adjustment: Adjust the length on nut E .
A
B
C
C
E
D
Adjustment of pendulum suspension (OLH)
Boom must be unfolded to working position. The boom
must be adjusted so the pendulum rod is vertical.
Ensure that the stabilizer rods
6 , 2 by 2 are of same
length.
WARNING! Do not detach all stabilizer rods at
the same time. The boom can fall out of the
suspension and cause severe personal injury.
Break-away (OLH)
The function of the break-away is to
prevent or reduce boom damage,
should it strike an object or
the ground.
Adjust on screw A
until the break-
away will re-
lease by a force
of 80 N at the
extremity. The
clutch must be well greased before adjustment is taking
place.
IMPORTANT: Check all counter nuts are tight after ad-
justment.
Transport bracket (OLH)
The left hand-side transport bracket position can be ad-
justed by removing the bolts. Be aware of legislation
regarding overall width during road transport.
Adjustment of inner section folding (OLH)
Boom must be unfolded to working position. Adjust in-
ner section/centre section alignment at adjustment
screw
5 .
T064-0003
T064-0005
T064-0004
T102-0002