Hardi ALPHA 2000, Инструкция

Страница: 19 / 52

19
ALPHA
4. Engage the pump and set engine speed at 2200 r.p.m.
5. Open FILLER lid.
6. Measure the correct quantity of chemical and fill it
into the hopper.
NOTE! The scale in the hopper can only be used if the
sprayer is parked at level ground! It is recommended to
use a measuring jug for best accuracy.
7. Open the bottom valve A and the chemical is trans-
ferred to the main tank.
8. If the chemical container is empty it can be rinsed by
the container rinsing device (if fitted). Place the con-
tainer over the multi-hole nozzle and press the lever
B .
Filling by HARDI FILLER chemical inductor
Liquid chemicals:
1. Fill the main tank
at least
1
/
3
with
water (unless
something else is
stated on the
chemical container
label). See section
“Filling of water”.
2. Turn the handle at
the Suction Mani-
fold towards “Main
tank” and turn blue
return valve to-
wards “Agitation”. Close remaining valves.
3. Turn the handle at the Pressure Manifold towards
“HARDI FILLER”. Close remaining valves. Check that
bottom valve
A at the FILLER is closed.
WARNING! Do not press lever B unless the
multi-hole nozzle is covered by a container to
avoid spray liquid hitting the operator.
IMPORTANT! Rinsing device uses spray liquid to rinse
containers for concentrated chemicals. Always rinse the
chemical containers with clean water several times until
they are clean before disposal.
9. Engage the hopper rinsing device by opening valve C .
10.Close valve C again when the hopper is rinsed.
IMPORTANT! The hopper rinsing device is using spray
liquid for rinsing the hopper for concentrated chemical!
The FILLER must always be cleaned together with the
rest of the sprayer when the spray job is done.
10.Close valve A and the FILLER lid again.
11.Turn handle at the Pressure Manifold towards “Inten-
sive Agitation” and close remaining valves.
12.When the spray liquid is well mixed, turn handle on
the Pressure Manifold towards “Spraying” position.
Keep P.T.O. engaged so the spray liquid is continu-
ously agitated until it has been sprayed on the crop.
Powder chemicals
Filling of powder chemicals is done as follows:
1. Fill the main tank at least
1
/
2
with water (unless some-
thing else is stated on the chemical container label).
See section “Filling of water”.
2. Turn the handle at the Suction Manifold towards
“Main tank” and turn blue return valve towards “Agita-
tion”. Close remaining valves.
Keep P.T.O. engaged so the spray liquid is continu-
ously agitated until it has been sprayed on the crop.
T020-0012
T020-0006
T042-0001
T020-0007
T020-0012