H3C XE 200/2000 IP, Руководство по эксплуатации

Страница: 57 / 514

Operation Manual – Process Server Configuration
H3C XE 200/2000 IP PBX
Chapter 3 Gatekeeper Configuration
3-2
Table 3-2 Assign an LS to the PS
Operation Command
Configure an LS entry for the PS by
specifying the local LS
ls-mode id-priority local
Configure an LS entry for the PS by
specifying the IP address of a remote LS ls-mode id-priority remote ip-address
ip-address
Configure an LS entry for the PS by
specifying the IP address and port
number of a remote LS
ls-mode id-priority remote ip-address
ip-address port port-number
Delete a specified LS entry or all LS
entries
undo ls-mode { id-priority | all }
III. Configuring heartbeat password
The LS learns about whether a PS is alive by listening to the keepalive messages sent
regularly by the PS. They use heartbeat password to identify each other. Therefore, the
heartbeat password configured for the PS must be the same as the one retained by the
LS. Any inconsistency will result in disconnection.
Perform the following configuration in LS view.
Table 3-3 Configure a heartbeat password
Operation Command
Configure a heartbeat password for the PS heartbeat password password
Restore the default undo heartbeat password
By default, the heartbeat password for the PS is XEngine.
IV. Configuring the identifier and interface of a PS
An LS uses PS identifier to distinguish between PSs. When configuring an identifier for
a PS, make sure that the same one is configured on the LS and the PS.
The interface specified using the ps-config command is a network interface on the
device where the PS is located.
Perform the following configuration in PS view.