Operation Manual – Call Services
H3C XE 200/2000 IP PBX
Chapter 9 Password Call Service
9-2
Note:
If the voice prompt service is not supported by the system, you are recommended to
pay attention to the rings. Busy tone indicates the failure operation, while the ringback
tone indicates successful operation.
II. Making password calls
The following table describes how to make password calls.
Table 9-2
Make password calls
Step
Expected result
Pick up the phone.
The subscriber can hear the dial tone.
Dial ABCD plus the called
number.
ABCD stands for the call password.
If the call password is correct, the call succeeds and
the subscriber can hear the ringback tone.
If not, the call fails and the subscriber will hear the
busy tone or the voice prompt “Sorry, the password is
not correct.”
Note:
Some subscribers need to add dialing terminator # to the end of the called number.
That is, these subscribers need to dial ABCD, the called number and # to initiate a
password call.
9.2 Password Call Service Configuration
9.2.1 Configuration Procedure
Table 9-3
Configure password call service
Operation
Command
Description
Enter system view.
system-view
—
Enter LS view.
location-server
—
Enter LS-GW view.
gateway device-id
Required
Enter subscriber number
view.
subscriber short-number
long-number
Required
Enable/disable the
password call service.
srv-switch pwd-call
{
on
|
off
}
Required
Содержание XE 200/2000 IP
