H3C XE 200/2000 IP, Руководство по эксплуатации

Страница: 33 / 514

Operation Manual – Basic Configuration
H3C XE 200/2000 IP PBX
Chapter 3 Basic Configuration
3-3
V. Setting the password used for switching the user level
If you log in as a user with a lower level and want to switch to a higher level, you need to
enter the password of a higher level, which should be set previously.
Perform the following configuration in system view.
Table 3-5 Set the password used for switching the user level
Operation Command
Set the password used for switching the
user level super password [ level user-level ]
{ simple | cipher } password
Remove the password that has been set
undo super password [ level
user-level ]
VI. Switching user level
To switch to a higher user level, you must enter a corresponding password.
Perform the following configuration in user view.
Table 3-6 Switch user level
Operation Command
Switch user level super [ level ]
VII. Locking user interface
When you are temporarily leaving, to prevent unauthorized access to the terminal
interface, you can lock user interface. You must enter and confirm a password to lock
user interface. To unlock and enter the user interface again, you must provide the
correct password.
Perform the following configuration in user view.
Table 3-7 Lock user interface
Operation Command
Lock user interface lock
VIII. Setting the command level
All commands fall into four levels, which are visit, monitor, system, and manage, whose
identifier ranges from 0 to 3. Administrators can assign the level of a command and the
view it belongs to as needed.
Perform the following configuration in system view.