H3C XE 200/2000 IP, Руководство по эксплуатации

Страница: 272 / 514

Operation Manual – System Management
H3C XE 200/2000 IP PBX Chapter 2 Terminal Service and User
Interface Configuration
2-8
Table 2-12 Configure the authentication mode
Operation Command
Set the authentication mode applied
when logging into a user interface authentication-mode { local | none |
password | scheme { list | default } }
Set the password for password
authentication set authentication password { simple
| cipher } password
II. Setting user level
1) Setting the level of a user interface
Perform the following configuration in user interface view.
Table 2-13 Set the level of the user interface
Operation Command
Set the level of the user interface user privilege level level
Restore the default level undo user privilege level
The privilege level of the console user interface defaults to 3; and the privilege level of
other user interfaces defaults to 0.
2) Assigning a level to a user
When the level of a user conflicts with the level of the user interface where the user logs
in, the former overrides the latter.
Perform the following configuration in system view.
Table 2-14 Assign a level to a user
Operation Command
Assign a level to a user local-user username level level
Restore the default user level undo local-user local-user level
The level argument is in the range 0 to 3, where 3 represents the highest level. By
default, no level is assigned to users.