H3C XE 200/2000 IP, Руководство по эксплуатации

Страница: 178 / 514

Operation Manual – Location Server Configuration
H3C XE 200/2000 IP PBX
Chapter 4 XE IP PBX Troubleshooting
4-5
Solution : On the LS, add the corresponding proxy server in LS view, and assign its
device identifier. Set a heartbeat password if authentication is required.
2) Cause 2 : The configuration of the corresponding proxy server on the LS does no
match that configured on the proxy server.
Diagnosis : Use the display current-configuration command to view the
configuration of the corresponding proxy server in LS view on the LS and in PS view on
the proxy server respectively, and check for the consistency of the device identifiers
and heartbeat passwords (if authentication is needed).
Solution 1 : On the LS, in LS-PS view configure the device identifier and the heartbeat
password (if authentication is needed) for the proxy server, making them consistent
with those configured on the proxy server.
Solution 2 : On the proxy server, configure the device identifier and the heartbeat
password (if authentication is needed), making them consistent with those configured
for the proxy server in LS-PS view on the LS.
3) Cause 3 : A remote LS is configured on the proxy server, but its IP address and
port are not consistent with those configured on the LS.
Diagnosis : Use the display current-configuration command to view the IP address
and port number of the remote LS in PS view on the proxy server and in LS view on the
LS respectively, and check for their consistency.
Solution 1 : On the proxy server, configure the IP address and port number for the
remote LS in PS view, making them consistent with those configured on the LS.
Solution 2 : On the LS, configure the IP address and port number in LS view, making
them consistent with those configured on the proxy server.
V. Proxy server can ping the LS, but cannot make a call normally
Cause : The heartbeat passwords of the proxy server and the LS are not consistent.
Diagnosis : Use the display location-server process-server all command to check if
the heartbeat password of the PS is consistent with that on the LS.
Solution 1 : On the LS, configure the heartbeat password in PS view, making it
consistent with that configured on the LS.
Solution 2 : On the LS, configure the heartbeat password in LS-PS view, making it
consistent with that configured on the proxy server.
VI. Multiple called parties fail to ring in turn
1) Cause 1 : Multiple UAs are not configured with the same called number.
Diagnosis : Use the display current-configuration command to check if the same
called number is configured in LS-GW view.
Solution : In LS-GW view, use the prefix or subscriber command to configure the
same called numbers, and prioritize them in descending order.