Operation Manual –IP Address-IP Performance
H3C S3100 Series Ethernet Switches
Chapter 1 IP Addressing Configuration
1-4
Note:
This chapter only covers how to assign an IP address manually. For the other two
approaches to IP address assignment, refer to the part discussing
DHCP
in this
manual.
Table 1-2
Configure an IP address to an interface
Operation
Command
Remarks
Enter system view
system-view
––
Enter interface view
interface interface-type
interface-number
––
Assign an IP address to
the Interface
ip
address
ip-address
{
mask | mask-length
}
Required
No IP address is assigned
by default.
Note:
z
A newly specified IP address overwrites the previous one if there is any.
z
The IP address of a VLAN interface must not be on the same network segment as
that of a loopback interface on a device.
1.3 Displaying IP Addressing Configuration
After the above configuration, you can execute the
display
command in any view to
display the operating status and configuration on the interface to verify your
configuration.
Table 1-3
Display IP addressing configuration
Operation
Command
Remarks
Display information about a
specified or all Layer 3
interfaces
display ip interface
[
interface-type
interface-number
]
Display brief configuration
information about a specified
or all Layer 3 interfaces
display ip interface
brief
[
interface-type
[
interface-number
]
]
Available in any
view
