K-BUS
KNX/EIB 3.5/5.0/10.1 inch Touch Panel Plus
19
○
R
⑥
Setting temperature
Touch
icon, you can enter the temperature setting interface, as shown in Figure 5.4_2:
Figure 5.4_2
Sliding slider for temperature adjustment, touch
and
icons, a 0.5-degree decrease/increase
adjustment can be made.
Icon
, used to determine the set temperature and return to function page.
The adjustment range of the set temperature is limited to 5-40°C by default, and can be modified by the
database “Min./Max. set temperature [5...40]°C”.
In the case of a relative set temperature, the adjustment of this set temperature is only applied to this mode in
the protection mode, and the relative change in the temperature adjustment of other modes can be applied to the
setting temperature of all modes except the protection mode. In the case of an absolutely set temperature, this
set temperature adjustment acts only on the current mode.
5.5 AC Feature page
Figure 5.5_1
①
On/off button
Used to turn on/off, 1 is gray after power on, and 1 is bright after shut down.
In the off state, except for the switch state and outdoor temperature that can be updated through the bus, the
rest of the icon states cannot be updated via the bus or manually controlled.
In the Gateway Integrate control mode, touch this button and the device will send a message with the value
①
②
③
④
⑤
Tip：The temperature units can be set via the parameter “Temperature display units”in the General window, for °
C or °F
