GSK GSK988TA, Руководство пользователя

Страница: 349 / 531

Chapter 8 Graph Setting & Display
331
Ⅱ
Operation
Chapter 8 Graph Setting & Display
8.1 Setting the Graph Parameters
Before setting the execution path, the relative information, like the path display or the graph
simulation, is set.
Setting the graph information is mainly for the graph display, like the offset amount of each
coordinate axis, the machining length, the diameter, the graph magnification and the graph simulation
proportion. The detailed setting steps are as below:
（
1
）
Press function key to enter the graph page set;
（
2
）
On the graph page set, press software key to enter the graph parameter setting
page, which is shown as Fig. 8-1:
Fig.8-1
（
3
）
Press , to switch between two channels;
（ 4 ） Press , key to select the setting item, like selecting the horizontal axis shown
as the above figure;
（
5
）
Press key to make the selected item to be input;
（ 6 ） Press , key to select the setting item, and then press key to confirm
the rewriting is completed.
（
7
）
Repeatedly operate to set other parameters.
Note: 1. In this page, the setting is only used the path display and diagram simulation
2. The path display and the graph simulation all are executed with the machine coordinate; if the path
and the graph are not displayed, the coordinate axis offset should be rewritten.
3. The horizontal axis must be the basic Z axis or the axis parallel to Z axis.