GRASS VALLEY Encore, Руководство по настройке

Страница: 305 / 426

Encore — Configuration Manual 305
RCL Server Application
Saving and Loading RCL Configurations
RCL client configuration data is saved to the SCB flash memory as well as
to the Sharer, the same as other panel configuration data. You cannot
modify RCL client configuration data if the Sharer is not on-line.
When a specific client configuration is modified, it is saved automatically
when you exit from the RCL configuration screen. The
Save and Save As
buttons in the Panel Server screen will re-save the same configuration
again, but this is redundant and so not required.The Panel Server
Load
button reloads the entire configuration (the RCL data along with the Panel
Server data) from the Sharer.
Tie-Lines and New Router Configurations
If the Router Controller contains a configuration without Tie Lines and a
new Router Controller configuration is loaded that contains Tie Lines, the
RCLNP GUI cannot retrieve the Tie Lines. Automation clients using the
RCLNP GUI can retrieve the Tie Lines after they have been saved from the
Tie Config screen.
When loading a new configuration with Tie Lines, saving the database (at
least once) and rebooting the system will allow automation clients to
retrieve the Tie Lines.
Serial Port Configuration
The Encore SCB COM2 port (a generic port that can be used with RCL Cli-
ents) comes configured from the factory with the following defaults:
Serial communication parameters are displayed and
available for editing when a Serial port has been selected.
Table 28. Default COM2 Port Settings
Parameter Value
Baud rate 9600
Data Bits 8
Stop Bits 1
Parity None
Handshake None