GRASS VALLEY Encore, Руководство по настройке

Страница: 200 / 426

200 Encore — Configuration Manual
Section 5 — Router Configuration
Note All panels, automation clients connected to the this Control system will use
the
S ource and Destination ID and the Name specified.
15.
Click on the
Config
button, and then click on the
Save
button.
Now you can test the configuration. Click on the
Main Menu
button and click
on the
Route
button. Perform a few Takes and verify the crosspoints change
on the remote system.
NP Matrix Redundancy
For redundancy, enter the primary IP address in the Net Name slot and the
contiguous IP address is considered as the secondary IP address i.e. the sec-
ondary MCPU IP address is the primary IP a1, the same as already
done for CPL matrix controllers. The connection is in the fail-over mode.
This NP matrix driver identifies connection loss to the SMS7000 when an
operation is requested or data is read back from the server. If the NP matrix
driver is configured for redundancy, when a connection loss occurs, con-
nection is then established with the redundant server. This is transparent to
the user. If the driver fails connecting to the redundant server, it returns an
error.
NP Matrix Protect and Unprotect
Native Protocol supports only Protects & Unprotects. (NP does not support
Soft Locks, Hard Locks, Force Unlock/Unprotect, Lock/Protect Override.)
Protects can be performed on individual Levels.
The Protects issued to the SMS7000 from Encore are retained by the
SMS7000 so long as the communications link between the two systems is
active.
A SMS7000 issued Protect cannot be unprotected or overridden by Encore.
A SMS7000 issued Protect must be removed by the SMS7000 issuing device.
An Encore issued Protect to a SMS7000 controlled Destination can be
unprotected by a SMS7000 GUI or Maintenance Interface or any other
Native Protocol client. The encore issued Protect can also be overridden by
the GUI or SMS7000 control panels configured with Protect Override. Oth-
erwise an Encore issued Protect would normally be removed by the Encore
issuing device or Encore control system.
NP Matrix Monitor Control
The NP matrix driver provides support for monitor control of the SMS7000
Destination. Only one default monitor is supported at the SMS7000 end.